10
9
GrandCanyonGasLogs.com
customerservice@grandcanyongaslogs.com
FOR YOUR SAFETY - LIGHTING INSTRUCTIONS
A. This appliance has a pilot which must be
lighted by hand.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air
and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
1. Do not try to light any appliance.
2. Do not touch any electric switch; do not use any
phone in your building
3. Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
4. If you cannot reach your gas supplier, call the
fire department.
5. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don’t try to repair it,
call a qualified service technician. Force or
attempted repair may result in a fire or explosion
6. Do not us this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to
replace any part of the control system and any
gas control, which has been underwater.
“WARNING – If you do not follow these instructions exactly, a fire or explosion may result caus-
ing property damage, personal injury or loss of life.”
LIGHTING INSTRUCTIONS FOR MILLIVOLT VALVE
1. STOP! Read the safety information above on
this label.
2. Push in gas control knob slightly and turn
clockwise to “OFF”
NOTE: Knob cannot be turned from ‘PILOT” to
“OFF” unless knob is pushed in slightly. Do not
force
3. Wait five (5) minutes to clear out any gas.
If you smell gas, STOP! Follow “B” in the safety
information above. If you don’t smell gas,
go to next step.
4. Find pilot – follow metal tube from the gas
control behind the burner.
5. Turn knob on gas
control-clockwise to
“PILOT”
6. Push in control knob all
the way and hold in
immediately light the
pilot with a match.
Continue to hold the
control knob in for about
one minute
after the pilot is lit.
Release knob and it will pop back up. Pilot should
remain lit. If it goes out, repeat steps 3-7
• If knob does not pop up when released, stop and
immediately call your service technician or gas
supplier
• If the pilot will not stay lit after several tries, turn
the gas control knob to “OFF” and call your
service technician or gas supplier
7. Turn gas control knob
counterclockwise to “ON”.
Control knob
Gas Inlet
Gas Outlet
Pilot screw
TO TURN OFF GAS TO APPLIANCE
1. Turn knob clockwise from “ON” position to the “PILOT” position. Push in the gas con-
trol knob slightly and turn clockwise to “OFF”. Do not force knob.
