6
5
GrandCanyonGasLogs.com
customerservice@grandcanyongaslogs.com
Remove all the burner components from the
burner kit and the valve control system parts from
the boxes. Locate the gas inlet on the left side of
the burner. Using a pipe wrench, rotate the gas inlet
180* degrees so that the inlet is facing the
front of the burner (this is for ALL 2-Burners,
Glass Burners, Kiva Burners, front view and see
through). For 3-Burners & Jumbo/Jumbo Slimline
Burners (front view and see through) rotate the gas
inlet 225* degrees so that the gas inlet to facing the
front of the burner pointing to the ground.
PRE-INSTALLATION
apply a small amount on the male pipe threads.
Leave the first two threads clean. Never use com-
pound on female threads as it might be pushed into
the control body.
6. The gas valve is multiposition and can be mount-
ed in any position (except upside down) without
affecting its operation.
7. Install gas valve so gas flow conforms with the
inlet and outlet of the control.
8. DO NOT insert any object other than suitable pipe
or tubing in the inlet or outlet of this control. Internal
damage may occur and result in a hazardous con-
dition. A backup wrench should only be used on the
wrench boss provided for this purpose, never on the
body of the control, as this could distort the casting.
NOTE: Do not overtighten any pipe connections,
as this could crack the valve body. A valve with a
cracked valve body will not be warrantied.
INSTALLATION
