Fire Pits Line Manual Operation
Page 7
5. The piping must be reduced to ½″ NPT or larger at the burner, as
shown in Figure 2.
6. At the burner assembly, install a 90° gas pipe elbow on the gas line
for proper installation of a gas hose. Do not kink or make a tight radius
bend on the gas hose.
7. Maintain good piping practice by keeping pipe length and elbows to
a minimum to eliminate unnecessary pressure drops. Corrugated flex
gas lines should not be used.
8. Install 90° pipe elbow and gas hose at the gas connection as shown in
Figure 2
9. Connect gas hose to the burner assembly.
10. With all gas connections tight, position the burner assembly so that it
sits level in the bowl. Rotate as required so that the gas hose rests in a
compact position.
IMPORTANT:
The mounting bracket must be installed for proper cooling
of the burner assembly. Mounting brackets must be
installed on the 48” Essex/45”Cielo/42” Legacy. Warranty
may be voided if the mounting bracket is not installed.
Do not kink or make sharp radius on the metal gas hose.
Do not come straight up with the gas hose. A 90° gas
pipe elbow must be installed on the gas line for proper
installation of the gas hose. The product warranty may be
voided if it is not installed with an elbow.
