washing programme.
The 16 steps of a module are described briefly below:
LOOP start
Set the LOOP start when a certain number of modules should be repeat-
ed; for example, to repeat pre-wash and wash twice in a row.
Module repetition
To repeat one module, for example two identical rinses, set this param-
eter and GUIDO
®
will carry out the module for the number of times set
before starting the following one.
Module type
Selection of the module type from those seen in 7.1.
Moreover, it is possible to define the name of the module. The name of
the module does not affect appliance operation. It is only a comment.
Weighing
This function can be activated only in the first module of the washing
programme. It determines if and how GUIDO
®
measures the weight of
the laundry loaded in the drum.
Level
Setting the water level inside the drum when the appliance is running.
Water loading
It determines how GUIDO
®
must load water in the drum. Only hot water,
cold water, balancing both, etc.
Soap loading
Setting the liquid detergent dosing units. In this step, you can set the
activation times of the signals for each of the 13 possible automatic liq-
uid detergent dosing units.
Temperature
Definition of the desired water temperature.
Heating
How the heating phase must be managed.
Hysteresis
Setting the hysteresis or heat-regulation values for heating
Heating speed
Sometimes the water heating speed needs to be reduced and therefore,
this parameter must be modified. A value equal to 0°C/min that the
function is disabled.
Drum movement
This step defines how the drum must move in terms of speed and right/
pause/left timing. It is the definition of the mechanical action to be ap
-
plied to the fabrics being washed.
