1
1.1
Detach the JG01 end cap from the 607 Ridge, and the J602A-E and J602B-E end caps from the 610 Gutters, you will only
need to remove the gutter end caps on the side that you are replacing a panel with a roof vent.
1.2
Slide 610 out of 609’s groove only as many panel sections as you need to access your preferred placement, as shown in
diagram . Remove the Y8 panel that you need to get to the area you are going to replace with a roof vent. Repeat on other side
if you have multiple vents you are going to install. Be sure to mark all panels you remove with an “X” to identify which side should
face the sun to be sure the correct side faces the sun.
REMOVING GUTTER INSTRUCTIONS
Warning:
This section is only for already built greenhouses. If you are just building your green-
house for the first time skip ahead to page 2 for roof vent assembly.
J602A-E
Z03
J601
Z03
J602B-E
Z03
J602B-E
Z03
J602A-E
Z03
J601
607
610
610
601B
601A
610
609
