P a g e
|
62
GWN7000 User Manual
Version 1.0.6.28
Gateway MAC Address
This field is required when using
Client Isolation,
so users will not lose
access to the Network (usually Internet). Type in the default LAN
Gateway’s MAC address (router’s MAC address for instance) in
hexadecimal separated by “
:
”. Example: 00:0B:82:8B:4D:D8
RSSI Enabled
Check to enable RSSI function, this will lead the AP to disconnect users
below the configured threshold in
Minimum RSSI (dBm).
Minimum RSSI (dBm)
Enter the minimum RSSI value in dBm. If the signal value is lower than the
configured minimum value, the client will be disconnected. The input range
is from “-94” or “-1”.
Enable Voice Enterprise
Check to enable/disable Voice Enterprise. The roaming time will be
reduced once enable voice enterprise.
•
The 802.11k standard helps clients to speed up the search for
nearby APs that are available as roaming targets by creating an
optimized list of channels. When the signal strength of the current
AP weakens, your device will scan for target APs from this list.
•
When your client device roams from one AP to another on the
same network, 802.11r uses a feature called Fast Basic Service
Set Transition (FT) to authenticate more quickly. FT works with
both pre-shared key (PSK) and 802.1X authentication methods.
•
802.11v allows client devices to exchange information about the
including
information
about
the
RF
environment, making each client network aware, facilitating
overall improvement of the wireless network.
Note:
11R is required for enterprise audio feature, 11V and 11K are
optional.
Enable 11R
Check to enable 802.11r
Enable 11K
Check to enable 802.11k
Enable 11V
Check to enable 802.11v
Upstream Rate
Set the maximum upstream rate
Downstream Rate
Set the maximum downstream rate
