P a g e
|
22
GXP17xx Administration Guide
Proxy
proxy cannot be connected.
BLF Server
Configures the optional server used for SUBSCRIBE requests to indicate other
extensions status on the SIP server.
SIP User ID
Configures user account information provided by your VoIP service provider
(ITSP). It's usually in the form of digits similar to phone number or actually a
phone number.
Authenticate ID
Configures the SIP service subscriber's Authenticate ID used for authentication.
It can be identical to or different from the SIP User ID.
Authenticate
Password
Configures the account password required for the phone to authenticate with
the ITSP (SIP) server before the account can be registered. After it is saved,
this will appear as hidden for security purpose.
Name
Specifies SIP server subscriber's name (optional) that will be used for Caller ID
display.
Voice Mail User ID
Sets if the phone system allows users to access the voice messages by
pressing the MESSAGE key on the phone. This ID is usually the VM portal
access number. For example, in UCM6100 IPPBX, *97 could be used.
Account x
Network Settings
DNS Mode
Defines which parameter will control how the Search Appliance looks up IP
addresses for hostnames. There are four modes: A Record, SRV,
NATPTR/SRV, Use Configured IP. The default setting is "A Record". If the user
wishes to locate the server by DNS SRV, the user may select "SRV" or
"NATPTR/SRV".
If "Use Configured IP" is selected, please fill in the three fields below:
Primary IP
Backup IP 1
Backup IP 2
If SIP server is configured as domain name, phone will not send DNS query,
but use “Primary IP” or “Backup IP x” to send SIP message if at least one of
them are not empty. Phone will
try to use “Primary IP” first. After 3 tries without
any response, it will switch to “Backup IP x”, and then it will switch back to
“Primary IP” after 3 re-tries.
If SIP server is already an IP address, phone will use it directly even “User
Configured IP” is selected.
NAT Traversal
Specifies which NAT traversal mechanism will be enabled on the phone system.
Users could select the mechanism from No, STUN, Keep-alive, UPnP, Auto or
VPN. The default setting is "No".
If set to "STUN" and STUN server is configured, the phone will route according
