P a g e
|
34
GXP17xx Administration Guide
setting is “Disabled”.
Paging Priority
Active
If enabled, during a multicast page if another multicast is received with higher
priority (1 being the highest) that one will be played instead. The default setting is
“Disabled”.
Multicast Paging
Codec
The codec for sending multicast pages, there are 5 codecs could be used: PCMU,
PCMA, G.726-32, G.729A/B, G.722 (wide band), G.723 and iLBC. The default
setting is “PCMU”.
Multicast Listening
Defines multicast listening addresses and labels. For example:
“Listening Address” should match the sender’s Value such as
“237.11.10.11:6767”
“Label” could be the description you want to use.
For details, please check the “Multicast Paging User Guide” on our Website.
Settings
Ring Tone
Call Progress
Tones:
System Ring Tone
Dial Tone
Second Dial Tone
Message Waiting
Ring Back Tone
Call-Waiting Tone
Busy Tone
Reorder Tone
Configures ring or tone frequencies based on parameters from local telecom. The
default value is North American standard. Frequencies should be configured with
known values to avoid uncomfortable high pitch sounds.
Syntax
: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]].
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence.
In order to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms
and a pause of OFF ms and then repeat the pattern. Up to three cadences are
supported.
Call Waiting Tone
Gain
This adjusts the call waiting tone volume. Users can select “Low”, “Medium” or
“High”. The default setting is “Low”.
Speaker Ring
Volume
Configures speaker ring volume. Valid range is 0 to 7.
Settings
Audio Control
Headset Key Mode
When headset is connected to the phone, users could use the HEADSET button
in "Default Mode" or "Toggle Headset/Speaker".
Default Mode
:
When the phone is in idle, press HEADSET button to off hook the phone
and make calls by using headset. Headset icon will display on the screen
in dialing/talking status.
When there is an incoming call, press HEADSET button to pick up the call
using headset.
When there is an active call using headset, press HEADSET button to
hang up the call.
When Speaker/Handset is being used in dialing/talking status, press
