GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.5.18
GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE
Page 34 of 87
initial signaling messages. The default setting is "No".
Caller ID Display
When set to "Auto", the phone will look for the caller ID in the order of
P-Asserted Identity Header, Remote-Party-ID Header and From Header in the
incoming SIP INVITE. When set to "Disabled", all incoming calls are displayed
with "Unavailable". When set to "From Header", the phone will display the
caller ID based on the From Header in the incoming SIP INVITE. The default
setting is "Auto".
Use Privacy Header
Controls whether the Privacy header will present in the SIP INVITE message
or not, whether the header contains the caller info. When set to "Default", the
Privacy Header will show in INVITE only when "Huawei IMS" special feature is
on. If set to "Yes", the Privacy Header will always show in INVITE. If set to
"No", the Privacy Header will not show in INVITE. The default setting is
"Default".
Use P-Preferred-Identity
Header
Controls whether the P-Preferred-Identity Header will present in the SIP
INVITE message. The default setting is "default": the P-Preferred-Identity
Header will show in INVITE unless "Huawei IMS" special feature is on. If set to
"Yes", the P-Preferred-Identity Header will always show in INVITE. If set to
"No", the P-Preferred-Identity Header will not show in INVITE.
Add Auth Header on
Initial REGISTER
To define whether authorization Header will be added on initial REGISTER
from the first REGISTER.
The default setting is “No”.
Allow SIP Reset
This is used to perform a factory reset through SIP NOTIFY. When the phone
receive the NOTIFY with event: RESET, the phone should perform a factory
reset after the authentication. The default setting is
“No”.
Account x
SIP Settings
Advanced Features
Line Seize Timeout
For Shared Call Appearance, phone must send a SUBSCRIBE-request for the
line-seize event package whenever a user attempts to take the shared line off
hook. “Line Seize Timeout” is the line-seize event expiration timer. The default
value is 15 seconds. The valid range is from 15 to 60.
Eventlist BLF URI
Configures the eventlist BLF URI on the phone to monitor the extensions in the
list with Multi-Purpose Key. If the server supports this feature, users need to
configure an eventlist BLF URI on the service side first (i.e.,
BLF1006@myserver.com) with a list of extension included. On the phone, in
this "eventlist BLF URI" field, fill in the URI without the domain (i.e., BLF1006).
To
monitor
the
extensions
in
the
list,
under
Web
GUI->Settings->Programmable Keys page, please select "eventlist BLF" in the
key mode, choose account, enter the value of each extension in the list.
Auto Provision Eventlist
BLFs
When option is enabled, empty multi-purpose keys will be automatically
provisioned to the monitored extensions in the Eventlist BLF. The default
