P a g e
|
71
HT818 Administration Guide
Version 1.0.27.2
Managing Firmware and Configuration File Download
When “Automatic Upgrade” is set “
Yes, every
” the auto check will be done in the minute specified in this
field. If set to “
daily at hour (0-23)”
, Service Provider can use P193 (Auto Check Interval) to have the
devices do a daily check at the hour set in this field with either Firmware Server or Config Server. If set to
“
weekly on day (0-6)”
the auto check will be done on the day specified in this field. This allows the device
periodically to check if there are any new changes need to be taken on a scheduled time. By defining
different intervals in P193 for different devices, Server Provider can spread the Firmware or Configuration
File download in minutes to reduce the Firmware or Provisioning Server load at any given time
Configuration File Download
Grandstream SIP Devices can be configured via the Web Interface as well as via a Configuration File
(binary or XML) through TFTP, HTTP/HTTPS or FTP/FTPS. The
Config Server Path
is the TFTP,
HTTP/HTTPS or FTP/FTPS server path for the configuration file. It needs to be set to a valid URL, either
in FQDN or IP address format. The
Config Server Path
can be the same or different from the
Firmware
Server Path
.
A configuration parameter is associated with each particular field in the web configuration page. A
parameter consists of a Capital letter P and 2 to 3 (Could be extended to 4 in the future) digit numeric
numbers. i.e., P2 is associated with the "New Password" in the Web GUI->Maintenance->Web/SSH Access
page->Admin Password. For a detailed parameter list, please refer to the corresponding firmware release
configuration template.
When the HT818
boots up or reboots, it will send a request to download a file named "cfgxxxxxxxxxxxx”
followed by a configuration XML file named "cfgxxxxxxxxxxxx.xml", where "xxxxxxxxxxxx" is the MAC
address of the phone, i.e., "cfg000b820102ab" and "cfg000b820102ab.xml". If the download of
"cfgxxxxxxxxxxxx.xml" file is not successful, the provision program will download a generic cfg.xml file and
then download cfg<Model>.xml. The configuration file name should be in lower case letters.
HT818 supports DHCP option 67allowing to provide custom name for the provisioning file. If DHCP option
67 is used, the following file download sequence will be applied:
Step 1: cfg<MAC>
Step 2: <option 67 bootfile>
→
cfg<MAC>.xml
→
cfg.xml
→
cfg<Model>.xml
Notes:
1. The Only acceptable Config file formats to be used when provisioning are XML or binary.
2. Make sure the MAC header on the Config file is the provisioned device’s MAC address or you can remove
the header completely.
For more details on XML provisioning, please refer to:
http://www.grandstream.com/sites/default/files/Resources/gs_provisioning_guide.pdf
