4
PHOTOVOLTAIC MODULES SAFETY
AND INSTALLATION MANUAL Rev. K
VALID IN NORTH AMERICA ONLY
Valid from September 2010
1305 S. Bertelsen Road Eugene, OR 97402
www.grapesolar.com
Tel: 1-877-264-1014 (toll free), 1-541-349-9000, Fax: 1-541-343-9000
II.
SAFETY PRECAUTIONS
1.
General Safety
1.1
Ensure that the modules are used for the intended purpose only.
1.2
When installing, operating and maintaining the PV system, observe all local, regional, national
and international statutory regulations, guidelines, norms and code requirements.
1.3
The safety information for other system components must also be followed.
1.4
Keep children away from the module and PV system.
2.
Handling Safety
2.1
The utmost care is required when unpacking, transporting, and storing the modules. Leave
modules in packaging until they are to be installed.
2.2
Always store the modules in a dry, ventilated in-door space if possible. If the un-connected
modules have to be stored outside for any length of time, always have the glass surface facing
down and cover modules with water-proof material to prevent water collecting inside the panel
and causing damage to exposed connectors.
2.3
Carry modules with both hands. Do not use the junction box as a handle to hold or transport the
module.
2.4
Do not stand or step on the module.
2.5
Do not drop module or allow objects to fall on module.
2.6
Do not mark or scratch the front or rear surface of the module with sharp objects.
2.7
Do not disassemble, modify or adapt the module such as drilling holes in the frame or glass. Do
not apply paint or adhesive to the module rear surface.
2.8
Do not remove any part or labeling installed by Grape Solar from the module. Doing so will
void the module warranty.
2.9
Keep all electrical contacts of module clean and dry. Do not handle modules when they are wet
unless wearing the appropriate protective equipment.
2.10
Do not leave a module unsupported or unsecured.
2.11
There are no user serviceable parts within the module. Do not attempt to repair any part of the
