www.grapesolar.com
Tel. 1-877-264-1014 (toll free), 1-541-349-9000, Fax: 1-541-343-9000
4
QuickStart Setup
Valid from June 2018
Step 10:
Uncover the panel. As the day progresses, you should see the battery voltage slowly increase, eventual-
ly the controller display will read “Float”. At this point the battery can be used to provide power (turn the
inverter on and plug your AC devices into it for power).
Step 9:
Connect the second red (positive) and black
(negative) 5-foot cable from battery to inverter.
GS-200-KIT EXPANDABLE PHOTOVOLTAIC
POWER GENERATION SYSTEM
CONFIGURATION MANUAL Rev. 180601
Exclusion for Documentation
UNLESS SPECIFICALLY AGREED TO IN WRITING, SELLER
MAKES NO WARRANTY AS TO THE ACCURACY, SUFFICIENCY, OR SUITABILITY OF ANY TECH-
NICAL OR OTHER INFORMATION PROVIDED IN ITS MANUALS OR OTHER DOCUMENTATION;
ASSUMES NO RESPONSIBILITY OR LIABILITY FOR LOSSES, DAMAGES, COSTS OR EXPENSES,
WHETHER SPECIAL, INDIRECT, CONSEQUENTIAL OR INDIDENTAL, WHICH MIGHT ARISE
OUT OF THE USE OF SUCH INFORMATION. THE USE OF ANY SUCH INFORMATION WILL BE
ENTIRELY AT THE USER’S RISK; AND
REMINDS YOU THAT IF THIS MANUAL IS IN ANY LANGUAGE OTHER THAN ENGLISH, ALT-
HOUGH STEPS HAVE BEEN TAKEN TO MAINTAIN THE ACCURACY OF THE TRANSLATION,
THE ACCURACY CANNOT BE GUARANTEED. APPROVED CONTENT IS CONTAINED WITH
THE ENGLISH LANGUAGE VERSION WHICH IS POSTED AT
Important: Installations of this kind must be certified/approved as “code-compliant” to the national and local build-
ing and electrical codes. Installers should have adequate knowledge of national and local code to ensure the installa-
tion passes inspection by the local electric authority.
Important: Proper fuses or breakers should be used to comply with all local and national codes. Contact Grape Solar
for specific recommendations.
Important: All batteries used for this system should be identical. Do not mix battery types or sizes. Do not mix old
batteries with new batteries. Performance and charging anomalies can occur if types, sizes, or age of batteries are not
identical.
Step 8:
Connect the bare wire end of the positive cable to
the “PV Positive” input of the controller, and the nega-
tive cable end to the other ‘PV Negative” input (the
terminals on the left side).
