Black Mark Label Instructions
Black Mark Label Calibration
In order to print labels with black marks,
the label stock needs to be calibrated.
To do so, with the printer power OFF,
hold the FEED/STATUS button down
while turning ON the printer. The feed/
status button will blink green twice,
switch to solid red, then begin to blink
red. Release the feed/status button
when it begins to blink red. Supply will
feed out while the printer calibrates to
the black mark.
Driver Settings for Black Mark Labels
For black mark labels with the 1/8" black mark, the settings on the
Stock
tab should
be as follows: “Print Method” should be set to
Thermal Transfer
, the “Media Type”
should be set to
Labels With Marks
.
NOTE:
It is possible that the position of the supply causes two labels to feed out; however, the third
label will be aligned correctly and ready to print.
Cut Labels in Intervals
To cut labels in intervals, you may do
so by setting the “Occurrence” to
After
Specifi ed Interval
under the
Stock
tab. Set the “Interval” to the number
of labels needed. Click
OK
to save your
settings.
-20-
Summary of Contents for DuraLabel 4000
Page 6: ... 4 ...
