24
●
Reduce pressure on the polisher when finishing work with it.
●
Use a cloth to remove remaining of each lacquer caring agent.
When using wax or other maintenance agents follow guidelines of their respective manufacturers.
Excessive wax or polishing paste application may cause the polishing pad to slip off the polishing-
buffing wheel.
SANDING
Coarse-grained abrasive paper is generally used for coarse processing of most materials, while fine-grained
paper is used for finishing works.
Attach a disc of sanding paper with gradation appropriate for planned task.
Abrasive paper must thoroughly adhere to the buffing-polishing wheel.
OPERATION
The tool is equipped with rotational speed stabilizing system, which ensures precision of work at varying
loads. Additionally there is a soft start system for better control.
Use only working tools with allowable rotary speed higher or equal to power tool rotary speed with
no load, and diameter not greater than recommended for the power tool type.
OPERATION AND MAINTENANCE
Unplug the power cord from mains socket before commencing any activities related to installation,
adjustment, repair or maintenance.
MAINTENANCE AND STORAGE
●
Always keep the power tool clean.
●
Do not use water or any other liquid for cleaning.
●
Clean the tool with a dry cloth or blow with compressed air at low pressure.
●
Do not use any cleaning agents or solvents, they may damage plastic parts.
●
Clean ventilation holes in the motor casing regularly to prevent device overheating.
●
In case of power cord damage replace it with a cord with the same specification. Entrust the repair to a
qualified specialist or return the tool to a service point.
●
In case of excessive commutator sparking, have the technical condition of carbon brushes of the motor
checked by a qualified person.
●
Clean the polishing pad and polishing sponges with water or water with mild soap only.
●
Always store the tool in a dry place, beyond reach of children.
Immediately replace worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always
replace both carbon brushes at a time.
Entrust replacement of carbon brushes only to a qualified person. Only original parts should be
used.
All defects should be repaired by service workshop authorized by the manufacturer.
TECHNICAL PARAMETERS
RATED PARAMETERS
Polisher
PARAMETER
VALUE
Supply voltage
230 V AC
Power supply frequency
50 Hz
Rated power
1100 W
Range of idle rotational speed
1000–3000 rpm
Summary of Contents for 59GP200
