Graphite 5902062592613, Instruction Manual

15

Putting the working pad away from processed surface during operation will allow dust to get out of the 

●

tool into the room where the work is carried out.
Efficiency and quality of processed surface depend heavily on type of sanding paper used and applied 

●

pressure. It is best to match the type of sanding paper by trials and errors.
When finishing sanding reduce pressure on the sander, switch off the motor and vacuum cleaner. 

●

Replace sanding paper when you observe signs of wear.

●

Make periodic breaks in operation.

●

Do not switch the sander on while its working pad is pressed against processed surface.

OPERATION AND MAINTENANCE

Disconnect the tool from power supply network before starting any adjustment, maintenance or 
repair.

●

Always keep the sander clean. 
Do not use water or any other liquid for cleaning.

●

Use brush to clean the sander.

●

Clean ventilation holes of the sander regularly to prevent motor overheating.

●

In case of excessive commutator sparking check technical condition of carbon brushes of the motor.

●

Store the sander in a dry place, beyond reach of children.

●

WORKING PAD REPLACEMENT

Replace immediately worn out or damaged working pad.

Loosen and unscrew the bolt that fixes the working pad (

●

8

) (

fig. H

).

Replace the working pad with a new one, fix with the bolt.

●

REPLACEMENT OF CARBON BRUSHES

Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always 
replace both carbon brushes at a time.
Entrust replacement of carbon brushes only to a qualified person. Only original parts should be 
used.

All defects should be repaired by service workshop authorized by the manufacturer.

TECHNICAL PARAMETERS

RATED PARAMETERS

Long Reach Sander

Parameter

Value

Supply voltage 

230 V AC

Current frequency 

50 Hz

Rated power 

600 W

Range of spindle rotational speed without load

600 - 1500 rpm

Sander length

1100 - 2000mm

Diameter of working pad

225 mm

Diameter of sanding paper

225 mm

Protection class

II

Protection level

IP20

Weight

5,5 kg

Year of production

2012