2-8
CHAPTER 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
CH 4. CUTTING DATA SAVED ON SD CARD
CH 2. CONNECTION AND PREPARATION
CH 4. CUTTING DATA SAVED ON SD CARD
2.4 Loading Media without Using the Carrier Sheet
(CC330-20 Only)
CHECKPOINT
If the media size is smaller than A4 size, be sure to use the carrier sheet. (Please see Section 2.3,
"Loading Media Using the Carrier Sheet".)
Meda loadng method
(1) Press the standby switch and confirm that the LED lamp is lit (green).
(2) Load the media in the Craft ROBO.
Align the left edge of the media with the right guideline on the front guide. Place the top edge
of the media against both push rollers, making sure that the media is straight.
CHECKPOINT
If a media wider than 220 mm is loaded, the guideline will be covered by the media.
However, if the media is loaded so that its top edge touches and is parallel to both
the push rollers, it will be straight.
Place the top edge of the media against both push rollers.
To ensure that the loaded sheet is
straight, align the left edge of the
media with the right guideline on
the front guide.
RIght guideline on the front guide
If you are using media that is not A4 size, please follow the instructions given below.
If the media width is between 210 and 270 mm
If the width of the media is between 210 and 270 mm, the only types of media that can be
loaded are vinyl films or sticker sheets.
If the media length is between 297 and 1,000 mm
The accuracy specification is guaranteed for media that measure 210 x 297 mm, but if the
media is film (with a thickness of 0.1 mm or less, and 0.3 mm or less including the backing
sheet (liner)), lengths up to 1,000 mm can be loaded.
•
•
