CHAPTER 2. CONNECTION AND PREPARATION
2-9
CH 2. CONNECTION AND PREPARATION
CH 4. CUTTING DATA SAVED ON SD CARD
CH 2. CONNECTION AND PREPARATION
CH 4. CUTTING DATA SAVED ON SD CARD
(3) Press
or
on the control panel to select <Load Media>, and press [ENTER].
Load
Media
Unload
Media
Select
File
When the SD card is not set in the SD card slot
When the SD card is set in the SD card slot
The Craft ROBO feeds the media automatically.
How to unload the meda
Press
to select <Unload Media>, and press [ENTER].
Unload
Media
Load
Media
The media is output toward the front of the main unit.
CHECKPOINT
When cutting is finished, <Unload Media> is displayed on the screen. In this case, just
press [ENTER] to unload media.
Allowable cuttng area
Make sure that your design fits within the allowable cutting area indicated below.
If the media is A4 size
Standard mode: The width of the allowable cutting area is 190 mm.
Expanded mode: The width of the allowable cutting area is 200 mm.
If registration marks are used, the allowable width is 190 mm.
CHECKPOINT
Follow the procedure below to change the mode from Standard to Expanded or
viceversa. The default setting is "Standard" mode.
1. In the Control Panel, open "Printers" ("Printers and Faxes" for Windows XP).
2. Open "Properties" for Graphtec CC300 or CC330.
3. Click [Printing Preferences] in the "General" tab.
4. Select the desired mode in "Margins" on the "Basic Setup" tab.
(If you create the cut data using the ROBO Master or Cutting Master 2, the [Expanded]
mode is selected.)
The allowable cutting area indicated above is applicable only when the media is set
correctly.
•
•
