2-8
Setting up The Cutter Plotter
(8) As shown in the figure below, pull on the medium at the front of the cutting plotter, so that the
medium's tension is equal at areas A and B.
B
A
(9) After confirming that the tension is equal, raise the media set lever to lower the push rollers
and hold the medium in place.
(10) Move the stock shaft stopper to the FREE position.
FREE position:
This is the status when the lever has been pushed down and engaged, and the silver-
colored section is hidden. The stock shaft rotates in the FREE status.
LOCK
FREE
CAUTION
While cutting or plotting is in
progress, please keep your
hands, hair, etc., away from
the shaft holder and the collar.
Silver-colored section
Black sticker
(11) Raising the media set lever displays a menu for selection of the media mode. Select the media mode.
R O L L 1 P R E S S E N T R
CHECKPOINT
If the
"REALIGN ROLLERS"
message is displayed when the medium is loaded and the media
set lever is raised, either the right-hand push roller is not positioned over the right-hand wide grit
roller or the left-hand or center push roller is not positioned over the grit roller. Check to confirm
that they are positioned correctly.
(12) Pressing the
or
key
displays
"ROLL1 PRESS ENTR"
,
"ROLL2 PRESS ENTR"
, and
"SHEET PRESS ENTR"
. Select
"ROLL1 PRESS ENTR"
or
"ROLL2 PRESS ENTR"
and
then press the
(ENTER) key
to confirm. When
"ROLL2 PRESS ENTR"
is selected, only
the medium width is detected. Select this mode to begin cutting at a point beyond the leading
edge. When
"ROLL1 PRESS ENTR"
is selected, the leading edge and width of the medium
are detected. Select this mode to begin cutting from the leading edge.