Setting up The Cutter Plotter
2-11
CHECKPOINT
If the
"REALIGN ROLLERS"
message is displayed when the medium is loaded and the media set
lever is raised, either the right-hand push roller is not positioned over the right-hand wide grit roller, or
the left-hand push roller is not positioned over the grit roller. Check to confirm that they are positioned
correctly.
Position push rollers (1) and (3) over the grit rollers to grip each edge of the medium, and position
push roller (2) over the grit roller nearest the center of the medium. The medium is gripped by the
three push rollers (1), (2), and (3).
Push roller (1)
Push roller (2)
Push roller (3)
Grit roller
Media sensor
Media
NG
OK
NG
OK
CAUTION
• Push roller (1) must be positioned over the right-hand wide grit roller.
• The medium must always be positioned over the media sensor.
For Minimum-Size Media
Position all of the rollers over the right-hand wide grit roller. Position the medium with the left-hand
edge aligned with the left-hand edge of the grit roller, and position the push rollers over both edges.
The minimum width of the medium that can be set is 85 mm.
Media
Push roller (1)
Push roller (3)
Grit roller
Media sensor
Push roller (2)
OK
CAUTION
• The medium must be at least 125 mm in length.
• The medium must always be positioned over the media sensor.
