4-14
Function Settings and Operations
4.11 Setting AUTO PRE-FEED
When the AUTO PRE-FEED function is set to
"ON,"
the medium is automatically fed forward and backward
by the preset length when data is received. This operation leaves traces of the grit rollers on the media and
prevents it from slipping during a cutting or plotting operation. Similarly, if roll media is used, the medium is
automatically pulled out by the cutting plotter.
(1) Press the
(PAUSE) key
to switch to PAUSE mode.
(2) Press the
(NEXT)
or
(PREV.) key
until the following menu is displayed.
A U T O P R E F E E D
(3) Press the
(ENTER) key
to display the AUTO PRE-FEED setting.
A U T O P R E F E E D O N
Press the
or
key
to select
"ON"
or
"OFF,"
and then press the
(ENTER) key
to confirm.
(4) If
"ON"
is selected and the
(ENTER) key
pressed, the feed-length setting is
displayed.
A U T O P R E F E E D 1 m
Use the
or
key
to set a value within the range of 1 m to 50 m, and then press
the
(ENTER) key
to confirm. To cancel the selection, press the
(NEXT)
or
(PREV.) key
.
(5) Press the
(PAUSE) key
to cancel PAUSE mode.
B L A D E W A R E S E T U P
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
P E N U P S P E E D
I N I T I A L F E E D
A D V A N C E D F U N C .
S E T U P M E N U
T E S T
F E E D & C U T
P E N U P / D O W N
A U T O P R E F E E D
C L E A R B U F F E R
