ii
Safety Precautions
Safety Precautions
WARNING
If the cutting plotter generates smoke, overheats, emits a strange odor, or otherwise functions abnormally,
do not continue using it. Turn off the power and unplug the power cord from the electrical socket.
• Use of the cutting plotter in such a condition may result in a fire hazard or
electric shock.
• After confirming that smoke is no longer being emitted, contact your sales
representative or nearest Graphtec vendor for repairs.
• Never attempt to perform repairs yourself. Repair work by inexperienced
personnel is extremely dangerous.
Do not disassemble, repair, or remodel the cutting plotter.
• Such action may cause electric shock or a fire hazard due to current
leakage.
• Contact with the high-voltage parts within the cutting plotter may cause
electric shock.
• If the cutting plotter requires repairs, contact your sales representative or
nearest Graphtec vendor.
Do not use the cutting plotter in a location where it will be exposed to water, rain, or snow.
• Such locations may cause electric shock or a fire hazard due to current
leakage.
Be sure to ground the earth terminal.
• If the cutting plotter is not grounded, the operator could suffer an electric
shock in the event of current leakage.
Do not connect the cutting plotter to a non-rated power supply.
• Use of a different supply voltage may result in electric shock or a fire
hazard due to current leakage.
Prohibited
No disassembly
Avoid water
Beware of
electric shock
Ground the
cutting plotter
Prohibited
