Setting up The Cutter Plotter
2-9
(13) After the medium size has been detected, the pen carriage returns to the origin point and the
cutting plotter awaits cutting data. If the INTERFACE conditions or COMMAND mode have not
yet been set, they should be set. If they have already been set, adjust the cutter pen. Once the
cutter pen has been adjusted, the cutting plotter is ready to perform cutting, so cutting data can
be sent from the application software on the computer.
Loading Sheet Media
(1) Lower the media set lever to raise the push rollers.
(2) Load the medium, aligning the edges with the upper and lower scales on the front guide.
Align with scale
Media sensor
CHECKPOINT
Load the medium so that it passes over the media sensor.
(3) Adjust the position of the left- and right-hand push rollers to suit the medium width.
(4) Raising the media set lever displays a menu for selecting the media mode. Select the media
mode.
S H E E T P R E S S E N T R
CHECKPOINT
If the
"REALIGN ROLLERS"
message is displayed when the medium is loaded and the media
set lever is raised, either the right-hand push roller is not positioned over the right-hand wide grit
roller, or the left-hand or center push rollers are not positioned over the grit roller. Check to confirm
that they are positioned correctly.
