2-10
Setting up The Cutter Plotter
(5) Pressing the
or
key
displays
"ROLL1 PRESS ENTR"
,
"ROLL2 PRESS ENTR"
, and
"SHEET PRESS ENTR"
. Select
"SHEET PRESS ENTR"
and then press the
(ENTER)
key
to confirm the selection. When
"SHEET PRESS ENTR"
is selected, the front and rear
edges are detected.
(6) After the medium size has been detected, the pen carriage returns to the origin point and the
cutting plotter awaits cutting data. If the INTERFACE conditions or COMMAND mode have not
yet been set, they should be set. If they have already been set, adjust the cutter pen. Once the
cutter pen has been adjusted, the cutting plotter is ready to perform cutting, so cutting data can
be sent from the application software on the computer.
Aligning the Push Rollers
Adjust the position of the left- and right-hand push rollers to suit the medium width. Position the
push rollers at either edge of the medium so that they are above the grit rollers. Adjust the push
rollers so that they are positioned above both the medium and the grit rollers. Positioning the push
rollers within the push-roller alignment marks ensures that they are above the grit rollers.
Push-roller alignment mark
NG
OK
NG
OK
CAUTION
To move the push rollers, the media set lever must be in the lowered position.
The push roller on the right-hand edge when viewed from the front must always be moved over the
right-hand wide grit roller.
Right-hand push roller
Right-hand grit roller
Media sensor
CAUTION
To move the push rollers, the media set lever must be in the lowered position.
