Basic Settings and Operations
3-3
Storing and Selecting Cutter Pen Condition Setting Areas
Eight different sets of user-defined cutting conditions can be registered in the plotter's memory as
COND Nos. 1 through 8. To specify a set of cutting conditions, you must first select the destination
COND. No. By selecting a different COND No., you can easily switch between pre-defined cutting
conditions for eight sets of media.
CHECKPOINT
The pen number settings for the CE3000-120AP are as follows:
Command-specified
pen number
1
2
3
4
8
COND. No.
1
2
3
4
8
Physical
pen number
1
(Pen holder)
2
(Cutter pen holder)
Storage method
Press the
(COND.) key
in READY mode to display the cutter-pen conditions.
2 0 9 U + 1 2 3 3 0 2
The current settings are displayed (from the left): condition number, PEN TYPE (cutter blade),
CUTTER OFFSET, FORCE, SPEED, and QUALITY.
The item to be changed is indicated by the
t
symbol. Press the
key
to change the symbol to
s
, and press again to move it to the right. Press the
key
to move it to the left. Use the
or
key
to select the parameter to be changed, and use the
or
key
to select the setting
details. Press the
(ENTER) key
to confirm. To cancel the selection, press the
(NEXT)
,
(PREV.)
, or
(COND.) key.
Selection method
To select condition settings that have previously been stored, use the
or
key
to select the
desired condition number stored on the cutter-pen-condition settings display (the number at the left
of the display), and then press the
(ENTER) key
. To cancel the selection, press the
(NEXT)
,
(PREV.)
, or
(COND.) key.
Setting TOOL (cutter blade or pen)
Set the type of pen (cutter blade) to be used.
(1) Press the
(COND.) key
in READY mode to display the cutter-pen conditions.
(2) Select the setting area (condition number) to be set, and then press the
or
key
to move
the
s
symbol to the position shown below.
2 0 9 U + 1 2 3 3 0 2
(3) Press the
or
key
to select
"09U," "15U," "15B,"
or
"PEN."
Press the
(ENTER) key
to confirm the selection. If other conditions are to be set, press the
or
key
to move the
s
symbol to the parameter to be set.
