4-22
Function Settings and Operations
4.18 Specifying the SPACE REAR Distance
The SPACE REAR function specifies the trailing margin of the medium. When cross-cutting is performed on
the basis of the TIMEOUT or SEPARATOR setting, cross-cutting is initiated at a coordinate position which is
the mX-axis position plotted plus the distance specified by the SPACE REAR setting.
(1) Press the
(PAUSE) key
to switch to PAUSE mode.
(2) Press the
(NEXT)
or
(PREV.) key
until the following menu is displayed.
A D V A N C E D F U N C .
(3) Press the
(ENTER) key
, and then press the
(NEXT)
or
(PREV.) key
until the following menu is displayed.
S P A C E R E A R
(4) Press the
(ENTER) key
to display the SPACE REAR setting.
S P A C E R E A R = 1 2 m m
Press the
or
key
to specify the distance of the trailing margin within the
range of
"7 mm"
to
"30 mm"
, and then press the
(ENTER) key
. To cancel
the selection, press the
(NEXT)
or
(PREV.) key
.
(5) Press the
(PAUSE) key
to cancel PAUSE mode.
CHECKPOINT
The setting is retained in the internal memory even when the power is turned off.
B L A D E W A R E S E T U P
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
P E N U P S P E E D
I N I T I A L F E E D
A U T O P R E F E E D
S E T U P M E N U
T E S T
F E E D & C U T
P E N U P / D O W N
A D V A N C E D F U N C .
C L E A R B U F F E R
