Function Settings and Operations
4-33
Setting the ORIGIN POINT
If the HP-GL command mode is set, the origin point can be set to the lower left or
center. The default setting is the lower left, so change this setting if your application
specifies a different origin position.
(1) Set the command setting to
"HP-GL."
C O M M A N D H P - G L
(2) Press the
(ENTER) key
to display the origin-point setting.
O R I G I N P T L . L .
(3) Press the
or
key
to select
"L.L."
(LOWER LEFT) or
"CENTER,"
and
then press the
(ENTER) key
to confirm. To cancel the selection, press the
(NEXT)
or
(PREV.) key
.
(4) Press the
(PAUSE) key
to cancel PAUSE mode.
