Preface
vii
Preface
Thank you for choosing a Graphtec CE5000-120AP cutting plotter. This cutting plotter employs a digital servo
drive system to achieve high-speed and high-precision cutting operations. Besides cutting apparel paper and
other media, it can also be used as a pen plotter.
To ensure good cutting quality and optimum productivity, be sure to read this User's Manual thoroughly
before use.
(1) Specified rating
(2) Watch out for electrical shock
(3) Prevent dust or metallic matter from adhering to the power supply connector.
Notes on this Manual
(1) No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or
by any means, without the prior written permission of Graphtec Corporation.
(2) The product specifications and other information in this manual are subject to change without notice.
(3) While every effort has been made to provide complete and accurate information, please contact your
sales representative or nearest Graphtec vendor if you find any unclear or erroneous information or wish
to make other comments or suggestions.
(4) Notwithstanding the stipulations in the preceding paragraph, Graphtec Corporation assumes no liability
for damages resulting from either the use of the information contained herein or the use of the product.
Registered Trademarks
All names of companies, brands, logotypes, and products appearing in this manual are the trademarks or
registered trademarks of their respective companies.
Copyright
This User's Manual is copyrighted by Graphtec Corporation.
Precautions regarding paper
Paper is easily affected by temperature and humidity, and starts to expand and contract immediately after it
has been pulled out from the roll. If cutting or plotting is started immediately after the paper has been pulled
out from the roll, expansion or contraction of the paper during the cutting/plotting operation may cause
misaligned cutting/plotting.
On this cutting plotter, the default settings for the two functions provided to prevent misaligned cutting/plotting
are "UNTIL: 180 seconds" and "PAPER LOAD: 2". To change these settings, see "4.34 Setting the PAPER
READY TIME" and "4.35 Setting the PAPER LOAD Function".
