Function Settings and Operations
4-35
4.30 Setting the PAGE LENGTH
This function sets the length of each page when long-axis cutting or plotting is performed using a roll
medium. This should be set for long-axis cutting or plotting exceeding 5 m in length. The default setting is
"5000 mm."
(1) Press the
(PAUSE) key to switch to PAUSE mode.
(2) Press the
(NEXT) or
(PREV.) key until the following menu is displayed.
S E T U P M E N U
(3) Press the
(ENTER) key, and then press the
(NEXT) or
(PREV.) key
until the following menu is displayed.
P A G E L E N G T H
(4) Press the
(ENTER) key to display the page-length menu.
L = 0 5 0 0 0 m m
Use the
or
key to move the cursor to the digit to be changed. Use the
and
keys to increase or decrease the setting, and then press the
(ENTER) key to confirm. To cancel, press the
(NEXT) or
(PREV.) key.
(5) Press the
(PAUSE) key to cancel PAUSE mode.
CHECKPOINT
• This setting is retained in the memory even when the power is turned off.
• The cutting plotter's distance precision is guaranteed for page-feed lengths of up to 3
meters. Long-axis cutting over 5 meters is possible for lengths of up to 50 meters in the
feeding direction.
• In the case of long-axis cutting, be particularly careful when loading the meduim. If the
meduim is loaded at even a slight angle, it may come loose from the rollers that hold it
in place.
CAUTION
• Before using roll paper, perform the pre-feed (see "4.10 Specifying the INITIAL FEED
LENGTH" and "4.11 Setting AUTO PRE-FEED") and paper acclimation (see "4.33
Setting the PAPER READY TIME" and "4.34 Setting the PAPER LOAD Function")
operations. (Precision is not guaranteed unless these operations are performed.)
• Make sure that the operating environment is within the range given for the guaranteed
precision operating environment and, in particular, that changes in temperature and
humidity are minimized insofar as possible.
• When cutting or plotting a long-axis design, use the paper receptacle (media basket)
with its opening widened.
B L A D E W A R E S E T U P
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
P E N U P S P E E D
I N I T I A L F E E D
T E S T
F E E D & C U T
P E N U P / D O W N
C L E A R B U F F E R
A U T O P R E F E E D
A D V A N C E D F U N C .
S E T U P M E N U
