Setting up The Cutter Plotter
2-9
Loading a Sheet Media
(1) Lower the media set lever to raise the push rollers.
(2) Load the medium, aligning the edges with the upper and lower scales on the front guide.
Media sensor
Align with scale
CHECKPOINT
Load the medium so that it passes over the media sensor.
(3) Adjust the position of the left- and right-hand push rollers to suit the medium width.
(4) Raising the media set lever displays a menu for selecting the media mode. Select the media
mode.
S H E E T P R E S S E N T R
CHECKPOINT
If the "REALIGN ROLLERS" message is displayed when the medium is detected, either the right-
hand push roller is not positioned over the right-hand wide grit roller or the left-hand or center
push roller is not positioned over a grit roller. Check to confirm that they are positioned correctly.
(5) Pressing the
or
key displays "ROLL1 PRESS ENTR", "ROLL2 PRESS ENTR", and
"SHEET PRESS ENTR". Select "SHEET PRESS ENTR" and then press the
(ENTER) key
to confirm the selection. When "SHEET PRESS ENTR" is selected, the front and rear edges
are detected.
(6) After the medium size has been detected, the pen carriage returns to the origin point and the
cutting plotter awaits cutting data. If the INTERFACE conditions or COMMAND mode have not
yet been set, they should be set. If they have already been set, adjust the cutter pen. Once the
cutter pen has been adjusted, the cutting plotter is ready to perform cutting, so cutting data can
be sent from the application software on the computer.
