4-36
Function Settings and Operations
4.31 Setting the SEPARATOR Function
The SEPARATOR function specifies a command for use as the separator. While receiving data from the
computer, the cutting plotter considers the receipt of the command specified by the SEPARATOR setting as
an indication that a complete set of data has been sent. After plotting all of the data received prior to receipt
of such command, the cutting plotter performs cross-cutting of the medium.
(1) Press the
(PAUSE) key to switch to PAUSE mode.
(2) Press the
(NEXT) or
(PREV.) key until the following menu is displayed.
S E T U P M E N U
(3) Press the
(ENTER) key, and then press the
(NEXT) or
(PREV.) key
until the following menu is displayed.
S E P A R A T O R
(4) Press the
(ENTER) key to display the SEPARATOR setting.
S E P A R A T O R =
Press the
or
key to specify one of the available SEPARATOR settings and
then press the
(ENTER) key.
GP-GL command mode:
"FS", "H", "J0", "F", "(blank)"
HP-GL command mode:
"IN", "DF", "PS", "IW", "SC", "IP", "SP", "NR", "PG", "AH", "AF", "(blank)"
To cancel the selection, press the
(NEXT) or
(PREV.) key.
(5) Press the
(PAUSE) key to cancel PAUSE mode.
CHECKPOINT
The setting is retained in the internal memory even when the power is turned off.
B L A D E W A R E S E T U P
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
P E N U P S P E E D
I N I T I A L F E E D
T E S T
F E E D & C U T
P E N U P / D O W N
C L E A R B U F F E R
A U T O P R E F E E D
A D V A N C E D F U N C .
S E T U P M E N U
