6-3
Setting the Tangential Mode
On/off and the mode of the tangental mode can be set ndvdually for each of 2-8 tool control numbers.
Operation
Supplement
Condition No.1 is pen specific. When setting
up tool condtons for the cutter plunger, please
choose from Condton No.2 to Condton
No.8 under "Selectng the Tool Condton". For
more nformaton, see "2.10 Selectng Tool
Condton"
P.2-29
.
1
Press the [COND/TEST] key.
CONDITION settng screen (1/3) s dsplayed.
2
Press the POSITION ( ) key.
CONDITION settng screen (2/3) s dsplayed.
3
Press the [3] key (TANGENTIAL MODE).
TANGENTIAL MODE settng screen s dsplayed.
4
Press the POSITION ( ) keys and select the tool condton
number (CONDITION No.).
5
Press the [1] key (MODE1), the [2] key (MODE2), or the [3]
key (OFF) and select the mode.
Supplement
It wll return to CONDITION screen (2/3)
wthout changng the settngs when you press
the [4] key (CANCEL).
6
Confirm the setting and press the [ENTER] key (SET).
Settng wll be set, and t wll return to CONDITION settng screen (2/3).
7
Press the [COND/TEST] key.
It wll return to default screen.
