6-4
Setting Length of the Overcut
Set the length of overcut wth tangental mode.
Operation
Supplement
Condition No.1 is pen specific. When setting
up tool condtons for the cutter plunger, please
choose from Condton No.2 to Condton
No.8 under "Selectng the Tool Condton". For
more nformaton, see "2.10 Selectng Tool
Condton"
P.2-29
.
1
Press the [COND/TEST] key.
CONDITION settng screen (1/3) s dsplayed.
2
Press the POSITION ( ) key.
CONDITION settng screen (2/3) s dsplayed.
3
Press the [4] key (OVERCUT).
OVERCUT settng screen s dsplayed.
4
Press the [1] key (Condton No.)
CONDITION No. selecton screen s dsplayed.
5
Press the POSITION (
) key and select the CONDITION
No.
6
Confirm the setting, and press the POSITION (
) key
(PREVIOUS).
Condton No. s selected and return to OVERCUT settng screen.
