3-5
Move Away the Tool Carriage
It is possible to move the tool carriage toward upper right. It makes it easier to confirm the cutting results if you
perform ths operaton after the cuttng s completed.
<When using Roll Media>: Seen from above
Poston of the pen carrage before movng away
To the bottom of the cuttng area
(machne orgn pont)
Standby poston of the pen carrage
<When using Sheet Media>: Seen from above
To the top of the
maxmum cuttng area
Bottom of the operaton area
(machne orgn pont)
Operation
Supplement
Tool carrage wll move away to upper rght by
contnuously performng the same operaton.
1
Press the [1] key (VIEW) n READY status.
Tool carrage wll move away.
To move the tool carrage to the orgn pont, do followng:
Operation
1
Press the [2] key (HOME) n READY status.
Tool carrage wll move to the orgn pont.
