4-2
Settngs such as area and wdth of cuttng, page length, mrrored, enlarged, shrunk, etc., can be set.
Setting Cutting Area
Supplement
See "Settng the Orgn Pont"
P.3-7
about the movng the orgn pont.
See "Settng Orgn Pont When HP-GL s
Set"
P.3-9
for settng the orgn pont wth
HP-GL command.
Orgn pont wll be set at lower left of the AREA once the AREA s
set. It s possble to set the orgn pont at the center when the HP-GL
s selected.
Move the orgn pont to change the cuttng poston.
Upper rght set
poston
Image already cut
Orgn
pont
It wll only cut wthn
ths range
Operation
Supplement
Perform the settngs n Normal menu.
See "How to Use Control Panel"
P.2-21
for READY status.
1
Press the [PAUSE/MENU] key n READY status.
MENU screen s dsplayed.
2
Press the [3] key (AREA).
AREA PARAMETERS settng screen (1/1) s dsplayed.
Supplement
Coordnate value dsplayed here s the
dstance to the tool carrage from the orgn
pont.
Press [1] key (DEFAULT) f the cuttng are s
not to change.
3
Press the [3] key (AREA).
SET LOWER LEFT screen s dsplayed.
4.1
Settings for Cutting
