GRAPHTEC CE6000 SERIES Replacement Manual Download

Page: 4 / 4

4/4

(5) The READY will be displayed after the backup was finished.

Turn off the power the after backup was finished.
The backup will be finished in about 30 seconds.

(6) Turn on the power while pressing the down arrow key and the ENTER key.

The following menu is displayed.

(7) Confirm that serial number is correct with the backup procedure.

And confirm the SERIAL_NUMBER and FACTORY_VALUE are showing the “OK”.

(8) Turn off the power for the CE6000.

Summary of Contents for CE6000 SERIES

Page 1: ...ch settings Set the dip switch settings with corresponding model to the NV RAM clear mode Dip Switch 1 2 3 4 Model SW1 1 2 3 4 ON OFF OFF OFF OFF ON CE6000 40 SW1 1 2 3 4 ON OFF ON OFF OFF ON CE6000 6...

Page 2: ...ew second 12 Turn off the power 13 End of replacing the main board When the Sub NV RAM values were not able to copy to the main board The Sub NVRAM valuer are not able to copy to the main board when t...

Page 3: ...number of the CE6000 For example if the serial number is E209200001 type as below a10 1 E209200001 Save the file after type it Procedure The back up command should be sent in the READY menu of mainten...

Page 4: ...backup will be finished in about 30 seconds 6 Turn on the power while pressing the down arrow key and the ENTER key The following menu is displayed 7 Confirm that serial number is correct with the bac...