3-4
Chapter 3 Cutting along Printed Data
Deciding the Distance Adjustment Volume
Measure the lengths of X (vertical) and Y (lateral) for the shape of the data (printed media) and the
shape that was cut.
Shape
Actually Cut
Media
Intended Shape to be Cut
Cut Value Y
Data Value Y
Data V
alue X
Cut V
alue X
Origin
Media T
ransport Dir
ection
5.
From the "MENU" screen, open the
"AREA 1/2" screen, proceed to the "AREA
2/2" screen, and input the offset and the
correction value for distance adjustment.
The space inside the white boxes for
numerical input can be touched to transition
to the input screen. Input the values for the
offset value in the X/Y directions and the
distance adjustment volumes in the X/Y
directions.
How to Input Numbers
Offset Volume:
Input the displacement amount and confirm the input with the
.
Distance adjustment volume:
Input the enlargement/reduction rate (%) and confirm the
input with the .
When the cut value is 50 mm and the data value is 51 mm,
(Data value [51] – Cut value [50) / Cut Value [50]) × 100 (%) = 2
so set +2% (after being set, the cut will be made at a length of
51 mm).
6.
Touch the
(Exit) to return to the "HOME" screen, load the printed media, and perform the cutting
operation.
7.
To make multiple cuts, send the data while changing the media.
Printing & cutting will be performed according to the tilt when the printed media is set.
Summary of Contents for CELITE-50
