3-8
Chapter 3 Cutting along Printed Data
Automatic Registration Mark Position Detection
The area of "A" is scanned from the registration mark scan starting position (position of the tool), and if a
registration mark is not located in the area of "A", the area of "B" is scanned.
Registration marks can be recognized as registration marks if they exist within the areas of "A" or "B".
100
100
100
A
A
B
B
100
Registration Mark
ScanStarting Position
Media T
ransport Dir
ection
It may be difficult to scan registration marks depending on the state of the media being used.
•
Transparent media
•
Media with blurry printed registration marks
•
Bent media
•
Media with a dirty surface
•
Media having a thickness of 0.6 mm or more
•
Laminated media (depending on the type and state of lamination)
•
Media on which black registrations mark lines are not printed on a white surface.
When using media on which black registrations mark lines are not printed on a white surface, set AUTO MARK
SCAN to OFF. (Refer to "Setting Automatic Registration Mark Position Detection")
Otherwise, configure the registration mark scan settings. (Refer to "5.6 Registration Mark Scan Settings")
Summary of Contents for CELITE-50
