5-16
Chapter 5 Detailed Settings
Correcting the Registration Mark Position
The sensor that scans the registration marks is located in a position that is away from the tip of the blade
tool. For this reason, it is necessary to make a correction so that the position actually being cut matches the
coordinates at which the registration marks were scanned.
If a registration mark has already been drawn on the media, scan that registration mark, draw another
registration mark in the same position, and then measure the volume of displacement between the two
registration marks. This volume of displacement will be used as the correction value.
If a registration mark has not been drawn on the media, plot a registration mark and scan this, and then draw
a registration mark again to measure the volume of displacement between the two registration marks. This
volume of displacement will be used as the correction value.
The accuracy of correction will increase when using media and the tool that are actually going to be used.
Once you are done with the setting, touch the (Exit) to return to the "HOME" screen.
Scanning the Printed Registration Mark for Correction and Entering the Correction Value
Scan the registration drawn on the media and make a correction by using the displacement between the scanned
position and the plotted position.
1.
Load media on which a registration mark for correction (a 40 mm cross with a line thickness of 0.4 mm)
has been drawn.
2.
From the "MENU" screen, open the "ARMS
1/2" screen and proceed to the "ARMS 2/2"
screen.
3.
Touch the "SENSOR OFFSET ADJ.".
4.
Touch the "SCAN".
5.
Use the " ", " ", "
" and " " to move the tool to the
registration mark scan starting area and touch the
(OK).
Media T
ransport Dir
ection
Registration Mark
Scan Starting Area
Registration Mark
for Correction
X
Y
Scan the registration mark and then plot a registration mark to use for comparison.
CAUTION
When the "OK" is touched, the media
and pen carriage will start moving.
Be careful to avoid contact with your
body or any object.
Distance
Adjustment Value Y
Distance Adjustment
Value X
Registration Mark
for Correction
Registration Mark
for Comparison
X
Y
Media T
ransport Dir
ection
Summary of Contents for CELITE-50
