5-3
5 ELECTRICAL ADJUSTMENTS
CC100-UM-251-9370
5.2 DIP Switch Settings
Factory presets (Normal Mode)
Set bits 1, 2, 3 and 4 to ON
ON
1
6
NOV-RAM clear mode
Set bits 1, 2 and 3 to ON
ON
1
6
5.3 Clearing the Non-Volatile RAM
When you replace the main board, you must clear the Non-Volatile RAM (NOV-RAM). If you clear the Non-Volatile
RAM, you will lose the setup parameters for each adjustment. Set up the adjustment values to the main board after
you clear the Non-Volatile RAM.
How to clear the Non-Volatile RAM
(1) Set the DIP switch to the NOV-RAM clear mode as shown below.
Set bits 1, 2 and 3 to ON
ON
1
6
(2) Connect the power cable to turn on the power.
(3) The Standby LED blinks when the NOV-RAM clear operation is complete.
(4) Turn off the power. (disconnect the power cable from the CC100-20.)
(5) Return the DIP switch setting to the normal mode as shown below.
Set bits 1, 2, 3 and 4 to ON
ON
1
6
