CHAPTER 3. CRAFT ROBO CONTROLLER
3.5.4 [About] Button
Displays the version information of the Craft ROBO Controller currently in use
3.5.5 [Cut] Button
Start cutting with the Craft ROBO. When the automatic reading of registration marks is specified, the
registration marks are read first. When the registration marks have been read successfully, the Craft
ROBO starts cutting.
3.5.6 [Cancel / Close] Button
Exits the Craft ROBO Controller.
3.5.7 Media Type Pull Down Menu
Media Type
Select the type of media to be
cut. The setup items are listed
below.
Thick Media
Select this item when paper thicker than
0.13 mm is used.
Thin Media
Select this item when paper thinner than
0.13 mm is used.
Pen
Select this item when the Craft ROBO with a pen (ballpoint pen) attached is used to
draw a line. Use a pen (ballpoint pen) primarily for trial plotting before cutting.
3.5.7-A Blade Adjustment Cap Indicator
For each media selected from “Media Type,” the Blade Adjustment Cap Indicator shows the color of the
blade adjustment cap to be attached to the blade holder before cutting.
Blade adjustment cap color controls the blade length. The color selection depends on the thickness of
the media to be cut.
3-12
