CHAPTER 3. CRAFT ROBO CONTROLLER
3.5.7-B Adjust Settings
If the results of the test cutting indicate that the conditions need to be adjusted, select the “Adjust
Settings” check box. As shown in the screen below, “Speed”, “Thickness”, “Test Cut” and “Add media”
are displayed. They are disabled when the “Adjust Settings” box is not checked.
3.5.7-C Track Enhancing
Speed:
Adjusts the cutting speed.
Selecting “Fast” increases the cutting speed, and selecting “Slow” reduces the
speed.
The slower the cutting speed, the higher the cutting quality.
The speed can be adjusted in 10 steps.
Thickness:
Specifies the thickness of the media to be cut.
Track enhancing refers to the action of moving the media back and forth several times before cutting is
started to improve the quality of cutting. It is performed automatically when the thickness exceeds a certain
value. Keep this function on during normal use. This function may be turned off to reduce the track
imprinting on the media provided you have verified that cutting is performed normally.
3-13
