CHAPTER 3. CRAFT ROBO CONTROLLER
(3) From the “Media Type” drop-down box of the Craft ROBO Controller, select the item corresponding to
the media used in the “Registration Mark Reading Test.”
(4) When you have finished preparing the “Test paper for the Registration Mark Reading” and loaded it
into the Craft ROBO, open the “Calibration” window and move the pen to the green square part of the
diagram.
You can click [Use Keyboard] in the “Blade Position” section of the Controller, and use the arrow keys
on the keyboard to move the cutter.
(5) Click [Registration Mark Reading Test]. After reading the printed cross, the pen will draw a cross.
Intersection point of the printed or
hand-drawn cross
Intersection point of the cross drawn
by the Craft ROBO
If the position of the intersection point recognized by the Craft ROBO is not aligned with that of the
printed cross, correct it as specified below.
Use the vertical (y) or horizontal (x) scroll bar to set a correction value.
The correction value must be in the range of
−
40 to 40.
One step represents 0.05 mm. For example, if 20 is specified as the correction value, the line drawn
by the pen (ballpoint pen) moves 1 mm.
If the position of the intersection point recognized by the Craft ROBO is not aligned with that of the
printed cross, set a correction value in accordance with the figures shown below. The red circle in the
diagram denotes the position of the intersection point plotted by the Craft ROBO.
3-21
