CHAPTER 2. CONNECTION AND PREPARATION
Cutting area
Available cutting area is shown in the diagram below. In addition, make sure that media edges are parallel with
the cutting guideline.
The possible cutting area varies with the mode you select.
In standard mode the cutting area is 190 mm in width.
In expanded mode the cutting area is 200 mm in width.
If registration marks are used the cutting area is 190 mm in width.
The above numbers are true only when media is loaded correctly along
the guideline.
Possible cutting
area
Media
Standard
10 mm
10 mm
5 mm
20 mm
Possible cutting
area
Expanded
5 mm
5 mm
5 mm
20 mm
2-4
