CHAPTER 3. CRAFT ROBO CONTROLLER
3-11
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Appendix A. Standard Specifications
Appendix A. Standard Specifications
Track Enhancing .......... Track enhancing refers to the action of moving the media back and forth several
times before cutting is started to improve the quality of cutting. It is performed
automatically when the thickness exceeds a certain value.
Keep this function on during normal use. If you need to shorten the cutting time,
this function may be turned off provided you have verified that cutting is performed
normally.
Test Cut ......................... Perform test cutting to check the cutting quality.
Use the [Blade Position] buttons to move the blade to the position at which test
cutting is to be performed, and then click the [Test Cut] button. A 1cm x 1 cm test
pattern will be cut. The cutting conditions are appropriate when the results of test
cutting indicate that the media is cut cleanly with faint traces of the blade on the
backing material (liner or carrier sheet). If cutting has not been performed correctly,
such as when the backing material itself is cut or uncut areas of film remain,
change the blade adjustment cap to one of a different color. Alternatively, change
the "Media Type" parameter or change the "Thickness" setting.
CHECKPOINT
• The quality of the cutting results will vary, depending on the type of
media to be cut and on other factors.
• If you plan to cut media that you have never used before, always be
sure to perform test cutting first.
Add Media ..................... Click the "Add Media" button to open the "Add Media" window.
A custom media type can be created by entering its settings and name.
