5-33
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
•
Enabling or Disabling Tool Up Movement [Default setting: DISABLED]
When the plotter receives commands that specify consecutive tool movements in raised status, this function
determines whether to move the tool to each coordinate point or to move the tool directly to the
fi
nal coordinate point.
When ENABLED is selected, the tool moves to each coordinate point in sequence.
When DISABLED is selected, the tool moves directly to the
fi
nal coordinate point.
•
Setting the PAUSE Function Display [Default setting: MENU]
This function determines what will be displayed on the LCD when the
[PAUSE] key
is pressed during a cutting or
plotting operation.
When HOLDING is selected, the cutting or plotting operation is paused and a CONTINUE/QUIT selection menu is
displayed.
When MENU is selected, the cutting or plotting operation is paused and the PAUSE menu is displayed.
•
Enabling or Disabling the Beeper [Default setting: ENABLED]
This function determines whether or not the beeper sounds each time a key on the control panel is pressed.
When ENABLED is selected, the beeper sounds
When DISABLED is selected, the beeper doesn't sound.
•
Enabling or Disabling the [ENTER] Key when a Tool Exchange Command is Received
[Default setting: DISABLED]
This function determines whether or not to use the
[ENTER] key
when a tool exchange command is received.
When ENABLED is selected, a tool exchange operation is not performed until the
[ENTER] key
is pressed. Select
this setting when you only want to use tool holder 1.
When DISABLED is selected, a tool exchange operation is performed automatically.
•
Circle Command Resolution Setting [Default setting: DEFAULT]
When the HP-GL command mode is selected, this function determines whether the resolution is automatically set or
fi
xed at the default value of 5 degrees when a circle command for a pen plotter is output.
Summary of Contents for CUTTING PRO FC2250 Series
Page 1: ...USER S MANUAL MANUAL NO FC2250 UM 151 FC2250 SERIES CUTTING PRO www delinit by...
Page 104: ...5 29 Chapter 5 FUNCTION SETTINGS AND OPERATIONS Cutting Plotting Conditions List...
Page 120: ...CHAPTER 8 SPECIFICATIONS PRODUCT SUMMARY 8 1 Main Specifications 8 2 External Dimensions...
Page 129: ...www delinit by...
