3-21
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
3.12 Using the Copy Function
This function allows you to automatically cut duplicates of the data sent from the computer. Once the data
has been stored in the plotter's receive buffer, it can be repeatedly cut.
(1) Send data to the plotter and then perform a cutting operation to enable the data to be stored in the plotter's buffer.
(2) Set the COPY origin. Use the
[
] [
] [
] [
]
keys
to move the pen carriage (the tip of the tool selected by the
current setting) to the desired starting position for cutting copies.
(3) Press the
[COPY] key
to select COPY mode. The following screen for setting the number of copies appears.
FORCE
OFFSET
SPEED
QUALITY
COPY MODE
COUNT 1
(4) Use the
[
]
or
[
]
key
to set the desired number of copies to be made. Be sure to set the number of copies no
higher than the maximum number of copies that can be cut out of the currently loaded medium.
(5) Press the
[ENTER] key
to start making copies.
(6) If you wish to set the spacing between copies, press the
[COPY] key
again. The following screen for setting the
spacing between copies appears.
FORCE
OFFSET
SPEED
QUALITY
COPY SPACE
1mm
(7) Use the
[
]
or
[
]
key
to set the spacing between copies.
Setting range: 1 to 10 (mm)
Your COPY SPACE setting is registered in the plotter's internal memory and retained even while the plotter is turned
off.
(8) Press the
[ENTER] key
to register your COPY SPACE setting and return to the display shown in Step 3.
(9) The "COPY" message is displayed and the plotter begins cutting the speci
fi
ed number of copies.
(10) If you wish to continue cutting more copies, reload a cutting medium and press the
[COPY] key
to start over again
from setting the number of copies.
(11) If the data to be copied will not
fi
t within the effective cutting area, the message below appears.
FORCE
OFFSET
SPEED
QUALITY
CANNOT COPY!
(12) In this case, use the
[
] [
] [
] [
]
keys
to move the starting position for cutting copies origin or replace the
loaded medium with a larger sheet.
If the Registration Mark mode has been speci
fi
ed, the registration marks are detected and only one copy is made.
Summary of Contents for CUTTING PRO FC2250 Series
Page 1: ...USER S MANUAL MANUAL NO FC2250 UM 151 FC2250 SERIES CUTTING PRO www delinit by...
Page 104: ...5 29 Chapter 5 FUNCTION SETTINGS AND OPERATIONS Cutting Plotting Conditions List...
Page 120: ...CHAPTER 8 SPECIFICATIONS PRODUCT SUMMARY 8 1 Main Specifications 8 2 External Dimensions...
Page 129: ...www delinit by...
