4-6
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
Setting the Registration Mark Spacing
(1) If registration mark 3, mirror 1 or mirror has been selected, the menu for setting the registration mark pattern spacing
is displayed.
FORCE
OFFSET
SPEED
QUALITY
MARK TYPE:3
SPACING = 3.0 mm
Use
the
[
]
or
[
]
key
to change the numeric value. When the displayed setting is satisfactory, press the
[ENTER]
key
to con
fi
rm your selection.
Setting range: 0 to 9.9 (mm)
Cutout area
Registration mark pattern Mirror 1
Registration mark pattern 3
Set value
Set value
Registration mark pattern Mirror 2
Set value
Set value
Set value
Set value
Setting the Center Registration Mark
The center registration mark can only be read for registration mark pattern 3, and only when "USER" has been selected
for the registration mark distance adjustment function.
(1) When registration mark pattern 3 has been selected and the
[ENTER] key
pressed, the menu for setting the center
registration mark is displayed.
FORCE
OFFSET
SPEED
QUALITY
CENTER W= --.-mm
X=----.-mm Y=---.-mm
(2) To perform plotting with the center registration mark as the reference point, press the
[F1] key
(CENTER) to af
fi
x the
black dot [
•
] next to CENTER and display the following menu. If you do not wish to perform plotting with the center
registration mark as the reference point, press the [F1] key once again to remove the black dot [
•
] and then press
the
[ENTER] key
.
FORCE
OFFSET
SPEED
QUALITY
•CENTER W= 00.0mm
X=0030.0mm Y=030.0mm
To perform plotting with the center registration mark as the reference point, press the
[F2]
,
[F3]
or
[F4]
key to
move the blinking cursor to X (X-axis length), W (center registration mark reading position) or Y (Y-axis length)
respectively. Use the
[
]
or
[
]
key
to move the blinking cursor, the
[
]
or
[
]
key
to change the numeric value
and the
[ENTER] key
to con
fi
rm your selections.
Setting range: [X/Y] 0 to 999.9 (mm), [W] -99.9 to +99.9 (mm)
a
W
b
W
Y
a
b
X
Vertical line
Horizontal line
Set W in the range in which there are no vertical or horizontal lines.
(3) Press the [PAUSE] key to cancel PAUSE mode.
Summary of Contents for CUTTING PRO FC2250 Series
Page 1: ...USER S MANUAL MANUAL NO FC2250 UM 151 FC2250 SERIES CUTTING PRO www delinit by...
Page 104: ...5 29 Chapter 5 FUNCTION SETTINGS AND OPERATIONS Cutting Plotting Conditions List...
Page 120: ...CHAPTER 8 SPECIFICATIONS PRODUCT SUMMARY 8 1 Main Specifications 8 2 External Dimensions...
Page 129: ...www delinit by...
