4-14
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
4.8 Setting the Registration Mark Detection Judgment Level
This function sets the color density judgment level of the line segments that are read during a registration
mark detection operation. This level determines the existence of a line segment by a change in density of the
speci
fi
ed percentage from an area where there are no line segments (white area).
(1) Load a medium in the plotter.
(2) Press the
[PAUSE] key
to select PAUSE mode.
(3) Press the
[NEXT] key
repeatedly until the following menu is displayed.
FORCE
OFFSET
SPEED
QUALITY
MARK TOOL U/D
BUFFER CLR. VIEW
(4) Press the
[F1] key
(MARK) to display the registration mark functions selection menu.
FORCE
OFFSET
SPEED
QUALITY
MODE DIST ADJ
TYPE OTHER SETUPS
(5) Press the
[F4] key
(OTHER SETUPS) to display the menu shown below.
FORCE
OFFSET
SPEED
QUALITY
SIZE ADJ. SENS
ORG OFT SENS OPT
(6) Press the
[F4] key
(SENS OPT) to display the menu shown below.
FORCE
OFFSET
SPEED
QUALITY
LEVEL
SENS SPD SENS STEP
(7) Press the
[F1] key
(LEVEL) to display the menu shown below.
FORCE
OFFSET
SPEED
QUALITY
SENSOR ADJ TYPE 3
1,2 TYPE MIRROR
To set the level for registration mark patterns 1 and 2, press the
[F2] key
(1,2).
To set the level for registration mark pattern 3, press the
[F3] key
(TYPE 3).
To set the level for registration mark pattern Mirror 1 or Mirror 2, press the
[F4] key
(MIRROR).
(8) If the
[F2] key
(1,2) was pressed, the menu for setting the sensor level is displayed.
FORCE
OFFSET
SPEED
QUALITY
LEVEL SETTING: 1,2
X=70% Y=70%
Use
the
[F2]
or
[F4] key
to move the blinking cursor to X or Y, and the
[
]
or
[
]
key
to change the numeric value.
When the displayed settings are satisfactory, press the
[ENTER] key
to con
fi
rm your selections.
Setting range: 1 to 99% [Default value: Registration mark pattern 1, 2 and MIRROR: X = 70, Y = 70;
Registration mark pattern 3: X = 85, Y = 85]
Select a numeric value that is appropriate for the difference between blank areas of the medium (areas where there
is no drawing) and the density of the registration marks. Setting a higher value enables higher sensitivity (faint
Summary of Contents for CUTTING PRO FC2250 Series
Page 1: ...USER S MANUAL MANUAL NO FC2250 UM 151 FC2250 SERIES CUTTING PRO www delinit by...
Page 104: ...5 29 Chapter 5 FUNCTION SETTINGS AND OPERATIONS Cutting Plotting Conditions List...
Page 120: ...CHAPTER 8 SPECIFICATIONS PRODUCT SUMMARY 8 1 Main Specifications 8 2 External Dimensions...
Page 129: ...www delinit by...
