5-9
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.8 Setting the Overlay Function
The Overlay function enables repeated cutting to be performed on a medium that cannot be cut with one
cutting operation. In the
fi
rst cutting operation, a cutting force that is lighter than the speci
fi
ed FORCE value
is used to leave cutting trace marks on the medium. For the second and subsequent cutting operations, the
speci
fi
ed FORCE value is used.
(1) Press the
[PAUSE] key
to select PAUSE mode.
(2) Press the
[NEXT] key
repeatedly until the following menu is displayed.
FORCE
OFFSET
SPEED
QUALITY
I/F FUNCTION
TOOL COND AREA OPT
(3) Press the
[F2] key
(TOOL COND) to display the menu shown below.
FORCE
OFFSET
SPEED
QUALITY
THICK CUT LINE
TOOL No. ADJ.T POS
(4) Press the
[F1] key
(THICK) to display the menu shown below.
FORCE
OFFSET
SPEED
QUALITY
THICK No.
OVERLAY
(5) Press the
[F2] key
(OVERLAY) to display the overlay settings screen.
FORCE
OFFSET
SPEED
QUALITY
Blinking cursor
COND No. 12345678
OVERLAY -9-7-6-4
The upper row of the display represents the cutting condition COND Nos. The lower row of the display indicates the
number of overlay operations that has been speci
fi
ed for each COND No.
Use the
[
]
or
[
]
key
to move the blinking cursor to the COND. No. for which you want to specify the Overlay
function, and the
[
]
or
[
]
key
to select the number of overlay operations.
Setting
range:
- (Off), 2 to 9 (times)
Press
the
[ENTER] key
to con
fi
rm your selection.
(6) Press the
[PAUSE] key
to cancel PAUSE mode.
•
These settings are retained in the plotter's internal memory even while the plotter is turned off.
•
If there are no data delimiter commands (such as F0 or PG), the plotter waits for a timeout (approx. 10 s) and then
starts the second cutting operation. In this case, the following screen appears, and operations such as changing the
COND No., making PAUSE menu settings and setting the origin cannot be performed until 10 seconds have elapsed
after all the cutting operations have been completed.
FORCE
OFFSET
SPEED
QUALITY
PREPARING TO RECUT
Summary of Contents for CUTTING PRO FC2250 Series
Page 1: ...USER S MANUAL MANUAL NO FC2250 UM 151 FC2250 SERIES CUTTING PRO www delinit by...
Page 104: ...5 29 Chapter 5 FUNCTION SETTINGS AND OPERATIONS Cutting Plotting Conditions List...
Page 120: ...CHAPTER 8 SPECIFICATIONS PRODUCT SUMMARY 8 1 Main Specifications 8 2 External Dimensions...
Page 129: ...www delinit by...
