5-13
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.12 Setting the Distance Adjustment Values
This function is used to correct any discrepancies in the lengths of the cut or plotted line segments. If, for
example, the DISTANCE ADJUST setting is speci
fi
ed as 0.05%, and the distance of the cut is 500 mm, the
cut distance is increased by 500 x 0.05% (= 0.25 mm), which means that the total cut distance is 500.25 mm.
(1) Press the
[PAUSE] key
to select PAUSE mode.
(2) Press the
[NEXT] key
repeatedly until the following menu is displayed.
FORCE
OFFSET
SPEED
QUALITY
I/F FUNCTION
TOOL COND AREA OPT
(3) Press the
[F3] key
(FUNCTION) to display the menu shown below.
FORCE
OFFSET
SPEED
QUALITY
B.G. SETTINGS
DIST. ADJ SORTING
(4) Press the
[F3] key
(DIST ADJ.) to display the distance adjustment values setting screen.
FORCE
OFFSET
SPEED
QUALITY
DIST.ADJ
X= 0.00% Y= 0.00%
Press
the
[F2] key
to move the blinking cursor to the X= parameter or the
[F4] key
to move the blinking cursor to the
Y= parameter, and then use the
[
]
or
[
]
key
to change the respective numeric value.
Press the
[ENTER] key
to con
fi
rm your selections.
Setting range: -0.25 to +0.25(%), in 0.05(%) increments
(5) Press the
[PAUSE] key
to cancel PAUSE mode.
These settings are retained in the plotter's internal memory even while the plotter is turned off.
Summary of Contents for CUTTING PRO FC2250 Series
Page 1: ...USER S MANUAL MANUAL NO FC2250 UM 151 FC2250 SERIES CUTTING PRO www delinit by...
Page 104: ...5 29 Chapter 5 FUNCTION SETTINGS AND OPERATIONS Cutting Plotting Conditions List...
Page 120: ...CHAPTER 8 SPECIFICATIONS PRODUCT SUMMARY 8 1 Main Specifications 8 2 External Dimensions...
Page 129: ...www delinit by...
